The driver files for the ATI Rage XC graphics display adapter, for Windows 95 and Windows 98. These drivers have been extracted from a Compaq support CD-ROM, to which the CVA included identifies the driver as being version 5.38 - however the included file README.W95 only refers to a driver version of 5.20. It is also likely that this driver may also work with other ATI Rage display adapters, please report any results in the comments below. README.W95 makes reference to the following: 4.0 Windows 95/98 ATI RAGE enhanced display driver problems The Windows 95/98 ATI RAGE enhanced display driver is capable of using monitor timing data contained within Windows 95/98. This data is selected by configuring a monitor type at Windows 95/98 installation time, or via the Settings page of the display properties sheet. If you change the selected monitor type via the Settings page of the display properties sheet, the new timing data may not take effect until after you restart Windows 95/98. A solution to this problem: always restart Windows 95/98 after changing the monitor type. The Windows 95/98 ATI RAGE enhanced display driver is capable of using monitor timing data contained within Windows 95/98. This data is selected by configuring a monitor type at Windows 95/98 installation time, or via the Settings page of the display properties sheet. The Windows 95/98 ATI RAGE enhanced display driver may incorrectly interpret Windows 95/98 monitor timing data for some older monitors that require interlaced modes. This may cause some options to be disabled. A solution to this problem: select one of the (Standard monitor types) available via the Settings page of the Display Properties sheet. In Windows 95/98, display drivers can be installed via the Add New Hardware wizard (although the procedure detailed in section 3.0 is recommended). When the Windows 95/98 ATI RAGE enhanced display driver is installed via the Add New Hardware wizard, the Settings page is not installed into the ATI RAGE...
Tags: ATI, graphics driver, ATI Rage XC